Vapor-Vac Hooded Induction Chamber | Patterson Scientific

Vapor-Vac Hooded Induction Chamber
78933385

The Vapor-Vac hooded induction chamber works with active vacuum waste gas management systems by allowing room air to be drawn into the waste anesthetic collection system as well as the waste gases from the induction chamber. If room air is not allowed to be pulled into the waste collection system, the vacuum will pull most of the fresh anesthetic gas out of the induction chamber before the animal is able to be anesthetized.

Our Vapor-Vac hooded induction chamber is constructed out of durable PVC plastic. Unlike research anesthesia induction chambers made out of acrylic, this chamber is shatter resistant and will not break down when exposed to harsh cleaning agents. Handles are made from durable acetal material for strength and cleanliness.

1-year product warranty

Questions? Contact us

1.800.877.8989

Features

Slide top lid which reduces exposure to waste anesthetic gases compared to lift style lid induction chambers
Vacuum (from either in-house vacuum or the EVAC 4) is applied to the EVAC fitting on the back of the hood of the induction chamber [link to /waste-anesthesia-gas-management/evac-4-evacuation-vacuum-attenuation]
A minimum 30 LPM negative flow creates a laminar flow, pulling in room air and drawing it over the release holes in the top rear of the slide top of the induction chamber
The release holes in the slide top are located just under the vacuum fitting in the back panel of the hood of the induction chamber
Durable PVC plastic
Durable acetal handle
Mouse and rat chamber

Specifications

7.25″ High x 6.25″ Wide x 12.25″ Deep
Inlet adapter 15 mm ID
Outlet adapter 19 mm OD
9 liters – to be used with vacuum